Rubber Band Method

This method utilizes rubber bands to keep a constant tension on the skin rather than a set screw or strap. This method is similar to how the DTR works and is derived from it.

Finished product will look something like this:

Building Instructions
1. Follow the same steps as the set Screw method
2. Drill an additional 1/8" hole on the opposite side of the coupling from the first screw
3. Thread screw into hole with phillips drill bit
4. Use saw or dremel to cut a notch in the top of each side of the PVC pipe as shown below.

5. Use rubber bands to provide tension as shown in diagram below

Usage instructions:
1. Apply tape as described in my other posts
2. Apply the pusher and PVC pipe to the coupling
3. Using one or two rubber bands, apply tension by attaching each end of the rubber band to the screws and notch as shown above
4. Adjust tension by either using an additional rubber band, or by moving one side of the band to the clamp (to increase tension)
5. Tug throughout the day

Urination instructions:
1. Remove the rubber band from the notch
2. Remove the pipe and pusher
3. urinate sitting down
4. replace the pusher and pipe
5. replace the rubber band and adjust tension